Manufacturer of Linear Modules,Linear Motors,Electric Cylinders,Truss System!
Facebook
LinkedIn
TikTok
YouTube
E-Mail
Linear Modules,Linear Motors,Electric Cylinders
Menu
MENU
MENU
Home
About Us
Linear Motion
Linear Modules
Belt Linear Module
Screw Linear Module
Multi Axis Linear Module
Helical Rack Pinion Linear Module
IP65 Bellows Cover Linear Module
Linear Motor Systems
Guide Rail Linear Motor Module
Linear Motor with Embed Guide Rail
Ironcore Flat Linear Motor
U Shape Ironless Linear Motor
Shaft Linear Motor
Linear Motor Drive
Linear Motor Feedback System
Electric Cylinders
Industrial Servo Electric Cylinder
Truss & Robot Track Systems
Truss Manipulator
Lathe Gantry Loader
Robot Ground Rail
Overhead Robot Track
News
Technical Guide
DownLoad
Contact Us
Linear Tool Changer configuration
Home
Linear Tool Changer configuration
How we design a Tool Changing Station Linear Slide?
September 22, 2026
Technical Guide
Tool Changing Station Linear Slide: A Dual-Rail Project From First Brief to 3D Model Author: DeMing, Engineering Director | Published: Sept 22, 2026 | Category: Technical Guide A track-mounted robot only earns its keep if it can change tools without waiting on an operator. In September 2026 a machine builder in Northern Ireland asked us for the mechanical half of that job: a tool changing station linear slide that pushes a tool rack out toward the robot, holds it there during the exchange, and pulls it back clear of the robot's travel path. This article follows the project from the first message to the 3D model we sent for approval, including the point where both sides were describing different machines. The Brief: Advance a Tool Box 900 mm Toward the Robot The first description arrived with two screenshots of the customer's cell layout and a reference image of a pneumatic slide. The robot runs on a floor track, and the tool rack sits beside the track. The slide had to close the gap between the two so the robot's wrist could reach the tools, then retract. Three numbers ...
Read more